Page 1 of 1
Voice Command Overload?
Posted: Mon Nov 22, 2004 9:59 pm
by Shigoto
Captains,
I find that at certain points in the game the voice command program takes leave of its senses. This seem to occur when an enemy vessel is in close proximity to my vessel.
I ask for "Roll Charges" and I get "All Back Full" or some such combination. While action is not close quarter everything works fine.
Anyone else experienced this???
Shigoto
Voice Command Overload?
Posted: Mon Nov 22, 2004 11:07 pm
by East
The voice command que may be overflowing. You can press the "V" key to turn the voice command on and off - helpful when you are getting these kinds of problems or severe lag in response time.
Voice Command Overload?
Posted: Mon Nov 22, 2004 11:56 pm
by Reaves
I've noticed back-ground noise can trigger commands. Try turning your mic volume down in your sound card mixer. I tend to do what East said and mute voice commands still.
Voice Command Overload?
Posted: Fri Nov 26, 2004 5:27 pm
by Sub Lt. D. Abramczyk
I understand this. When I'm doing the "Torp the Tankers" patrol every time a plane buzzes me a torpedo is fired.
Voice Command Overload?
Posted: Fri Nov 26, 2004 10:50 pm
by Torgen
Guess that's one more advantage to using a headset/microphone setup!

Voice Command Overload?
Posted: Fri Nov 26, 2004 11:35 pm
by Jesper
Abram go to the speech settings in windows's control panel and adjust the accuracy setting.
Voice Command Overload?
Posted: Sat Nov 27, 2004 6:17 pm
by Sub Lt. D. Abramczyk
Well, since my PC went Ka-blooey, the headphones no longer work. At all.
Voice Command Overload?
Posted: Sat Nov 27, 2004 7:57 pm
by Shigoto
Well, since my PC went Ka-blooey, the headphones no longer work. At all.
Sorry Mate, about the puter. Hope all else is well in lovely Auckland.
Jesper suggested when not using voice command to hit the "V" key and mute it. When you want to give and order hit the "V" key again. Keeps the channel from overloading and botching things up.
Shigoto

Voice Command Overload?
Posted: Sat Nov 27, 2004 8:32 pm
by Jesper
Well, since my PC went Ka-blooey, the headphones no longer work. At all.
Sorry Mate, about the puter. Hope all else is well in lovely Auckland.
Jesper suggested when not using voice command to hit the "V" key and mute it. When you want to give and order hit the "V" key again. Keeps the channel from overloading and botching things up.
Shigoto
that wasnt me but Kelly

:P